Publicidad
Idiomas disponibles
Idiomas disponibles
Assigning the Clamp Identifier ("T" number)
T1 should be used for Suction Line (Low Side) and T2 should be used for the Liquid Line
(High Side).
1. Press and hold ENTER button to enter the menu
2. Press POWER button to cycle to "Clamp #"
3. Press ENTER button
4. Cycle through the numbers and press ENTER button when the desired number
is highlighted
5. The clamp will restart and the new clamp identifier number will be used
Colored Bands
The Blue band should be used for the "T1" clamp. The Red band should be used for the
"T2" clamp. Colored bands can be changed out for easy identification. Simply pull off the
band and replace it with the desired color.
Changing Temperature Units
1. Press and hold ENTER button to enter the menu
2. Press POWER button to cycle to "Units," and then press ENTER button to
select continue
3. Press POWER button to cycle through the units and press ENTER button to
select the units
Adjust/Reset the Temperature
1. Press and hold ENTER button to enter the menu
2. Press POWER button to cycle to "Temp. Cal." and press ENTER button to adjust
temperature or reset to factory calibration
To Adjust: Press POWER button to cycle to "Adjust" and press ENTER button.
Follow prompts to manually set the temperature to the desired value.
To Reset to factory defaults: Press POWER button to cycle to "Reset" and press
ENTER button.
JB INDUSTRIES • Wireless Temperature Clamps Operating Manual • 630.851.9444 • sales@jbind.com
5
Publicidad
