Descargar Imprimir esta página

KNOVA KN AP-125B Manual Del Usuario página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

SETUP
Before setting up your machine you should read and
understand the instructions given in this manual.
The unpainted surfaces of this planer are coated with a rust
preventive waxy oil that you will want to remove before you
begin assembly. Use a solvent cleaner that will not damage
painted surfaces.
UNPACKING
The machine is properly packaged and shipped completely in
carton for safe transportation. When unpacking, carefully
inspect the carton and ensure that nothing has been damaged
during transit.
Open the carton and check that the machine and the parts
are in good condition.
PROPER GROUNDING
Grounding provides a path of least resistance for electric
current to reduce the risk of electric shock.
Make sure the cord is plugged into a properly installed and
grounded power outlet. To prevent electrical hazards, have
a qualified electrician ensure that the line is properly wired.
Make sure that the planer is connected to an outlet having
the same configuration as the plug. If an adaptor plug is used,
it must be attached to the metal screw of the receptacle.
It is strongly recommended not to use extension cords with
your KN AP-125B. Always try to position your machine close
to the power source so that you do not need to use extension
cords.
if it is necessary to use an extension cord, make sure the
extension cord does not exceed 50-feet in length and the cord
is 14-gauge to prevent motor damage.
MOUNTING
The KN AP-125B features pre-drilled holes on the base that
allow mounting the planer to the workbench.
If you choose to permanently mount your planer to
the workbench, use the four pre drilled holes on the base.
See figure-2.
The holes are drilled all the way through the workbench,
and hex bolts, washers, and hex nuts are used to secure
the planer to the workbench.
You can also mount the planer directly to the workbench using
a lag screw.
WARNING
KN AP-125B is a heavy machine, do not overexert
yourself. For safe moving method use a mechanical
device or get the help of an assistant.
IMPORTANT
While unpacking the KN AP-125B, if you can not find
any part of the machine, check if it is already installed
on the machine. Some parts come installed on the
machine due to shipping purposes.
LIST OF CONTENTS
A. Planer ............................. 1
B. Chip Deflector ................ 1
C. Crank Handle.................. 1
D. Rubber Feet.................... 4
110 - Volt grounded outlet
Grounded pin
WARNING
Improper connection of the equipmentgrounding
conductor can result in the risk of electric shock.
Check with a qualified electrician if you are in doubt
as to whether the outlet is properly grounded.
Mounting
holes
3
KN AP-125B mounting holes and rubber feet
QTY
LIST OF CONTENTS
E. Knife Gauge.................... 1
F. Hex Wrench .................... 1
G. Cap Screw ..................... 1
H. Lock Washer................... 1
110 - Volts outlet for KN AP-125B
QTY
Figure 1
Rubber
feet
Figure-2

Publicidad

loading