FOR-X XAP-200.4D Manual Del Propietário página 3

www.for-x.com.tr
POWER CONNECTION
BATT ( 12V POWER )
Before mounting amplifiers, disconnect the negative cable from the battery to protect any accidental damage
to your amplifiers and audio system. Connect the power cables to power terminal 12V.
All XAP-series amplifiers are not equipped with fuses. External fuses should be used.
Connect one end of fuse holder to the power cable going into the amplifiers and the other end of fuse holder to
positive battery. This fuse location will protect the system and the vehicle against the possibility of a short
circuit in the power cable. Be sure to use a fuse and fuse holder adequate for the application.
GND ( GROUND )
Locate a secure grounding connection as close to the amplifier as possible. Make sure the location is clean and
provides a direct electrical connection to the frame of the vehicle. The ground needs to have as low of a
resistance as possible. Connect one end of a short piece of the same size cable as the power cable to the
grounding point or to one of your batteries or battery bank. Run the other end of the cable to the mounting
location of the amplifiers for connection to the amplifiers ground terminals and connect the ground cable to the
GND ( ground terminal ).
REM ( REMOTE )
Run a remote turn on cable from the switched 12V source . This may be a toggle switch, a relay, your source
unit's remote trigger cables, or power antenna trigger cable. Connect the remote turn on cable to the REM
( remote ) terminal.
ENGLISH
02