Notice: Component parts shall be replaced with like components so as to
minimize the risk of possible ignition due to incorrect parts.
The appliance is to be installed in accordance with the Safety
• WARNING
Do not use means to accelerate the defrosting process or to clean, other
than those recommended by the manufacturer.
The appliance shall be stored in a room without continuously operating
ignition sources(for example: open flames, an operating gas appliance or
an operating electric heater.
Do not pierce or burn.
Be aware that refrigerants may not contain an odour.
• Warning: The appliance shall be stored in a well-ventilated area where
the room size corresponds to the room area as specified for operation;
Warning: The appliance shall be stored in a room without continuously
operating open flames (for example an operating gas appliance) and
ignition sources (for example an operating electric heater). Warning: The
appliance shall be stored so as to prevent mechanical damage from
occurring.
• Check that cabling will not be subject to wear, corrosion, excessive
pressure, vibration, sharp edges, or any other adverse environmental
effects. The check shall also take into account the effects of aging or
continual vibration from sources such as compressors or fans.
• Before carrying out Decommissioning procedure, it is essential that the
technician is completely familiar with the equipment and all its detail. It is
recommended good practice that all refrigerants are recovered safely. Prior
to the task being carried out, an oil and refrigerant sample shall be taken in
case analysis is required prior to re-use of recovered refrigerant. It is
essential that electrical power is available before the task is commenced.
When removing refrigerant from a system, either for servicing or
decommissioning, it is recommended good practice that all refrigerants are
removed safely.
The recovery equipment shall be in good working order with a set of
instructions concerning the equipment that is at hand and shall be suitable
- 4 -