dirna Bergstrom TRP Dynamic Instrucciones De Montaje página 23

TRP Dynamic
On the studs, thread (4) M6 nuts with (4) flat
8
washers Ø 6, which should be level with the
cover.
SEE ATTACHED DIAGRAM
VERY IMPORTANT
!
In the case of slanting upholstery, the
evaporator unit must be vertical to prevent the
condensation water from dropping onto the
upholstery.
Pass the waste water pipe through the bore of
9
the evaporator base and connect to the tray.
Pass the cabling through the Ø 35 bore towards
10
the exterior.
OPERATIONS VALID FOR ALL MODELS
Upholstery
Evaporator
bracket
Waste water
tray
Waste water pipe
10
Air conditioning for vehicles
Lorry sheet
OUTSIDE
M6 self-blocking
nut
Protector cap
M6 Stud
Wide ring flat
washer
Rubber washer
9
23
Upholstery
INSIDE
Evaporator M6 Nut
base (leave at
M6 Nut upholstery height)
M6 Nut
Wide ring
Wide ring
flat washer
flat washer
EN
8
10