TECshow NAVIGATOR SMART RDM Manual De Usuario página 8

7. Reset factory
(to restore the factory settings)
1. Rotate the PAN wheel to locate 02. Reset factory.
2. Press ENTER to confirm.
Rotate the PAN wheel to select YES or NO.
3.
4. Press ENTER to confirm or press ESC to return to
the main menu.
8. Delete all Fixture patch
1. Rotate the PAN wheel to locate 03. and then
delete all Fixture patch".
2. Press ENTER to confirm.
3. Rotate the PAN wheel to select YES or NO.
4. Press ENTER to confirm or press ESC to return to
the main menu.
9. Fade mode
Setup controller fade mode.
•
ALL CHANNEL: run chases, all channels will fade
in and fade out.
•
ONLY PAN/TILT: run chase, onlay PAN/TILT have
fade in and fade out.
1. Rotate the PAN wheel to locate "04.
Fade mode"
2. Press ENTER to confirm.
3. Rotate the PAN wheel to select ALL
CHANNEL or ONLY PAN/TILT.
4. Press ENTER to confirm or press ESC to
return to the main menu.
10. RDM DMX Address setup
•
Rotate the PAN wheel to locate "05. RDM DMX Ad-
dress setup".
•
Press ENTER to confirm.
•
Rotate the PAN wheel to select YES or NO; If YES
you will enter RDM operation.
•
Show Design 2 will start searching RDM devices
and will show the number of RDM devices.
P. 8
NAVIGATOR SMART RDM
ENGLISH VERSION
•
Rotate the PAN wheel to select an RDM device; ro-
tate the TILT wheel to adjust the DMX address of
the RDM device. Press ENTER to confirm.
•
Press SWAP to switch the information of the se-
lected device; Press DEL to verify selected dvice.
•
Press ESC to return to the main menu.
11. Data backup
•
Rotate the PAN wheel to locate 06. Data backup.
•
Press ENTER to confirm.
•
Rotate the PAN wheel to select YES or NO; press
ENTER to confirm.
•
Press a number button(1-12) to store the back-up
file. 12 files can be backed up in Show Design 3,
respectively stored in Number 1-12 buttons. If the
LED indicator of a number button is on, it means
there is back-up file in this position.
•
Press ESC to return to the main menu.
12. Data Load
•
Rotate the PAN wheel to locate "07. data load",
•
Press ENTER to confirm.
•
Rotate the PAN wheel to select YES or NO; Press
ENTER to confirm.
•
Press a number button (1-12) to load the back-
up file. 12 files can be backed up in Show Design
3, respectively stored in Number 1-12 buttons. If
the LED indicator of a number button is on, it
means there is back-up file in this position.
13. Send fixture Update file
•
Through the DMX cable, send fixture firmwarcode.
•
Insert a USB memory stick to the USB port.
•
Rotate the PAN wheel to locate "08. Send fixture
Update file".
•
Press ENTER to confirm.
•
Rotate the PAN wheel to locate the file to send.
•
Press ENTER to start sending.
•
Repeat Step 5 to send another file.
•
Press ESC to exit.