Signal Led - DeLorme inReach Guia De Inicio Rapido

connected PN-60w) or taking out the batteries will NOT
tell GEOS to stop the rescue. If you replace the batteries
when an SOS is in progress, press and hold the SOS but-
ton again to update your location.
For more information about GEOS,
visit geosalliance.com.

Signal LED

The Signal LED indicates the status of the connection
between the inReach and the GPS satellites or Iridium
satellites. Green flashes indicate that messages or track-
ing points are being sent. Red flashes indicate that you
don't have a good signal and messages or tracking points
aren't being sent.
• The Signal LED flashes green once every three
seconds when the inReach is sending a message
of any type. The LED will stop flashing when the
message is sent unless the inReach is tracking in
standalone mode.
• The Signal LED flashes red once every three seconds
when there is a problem sending or confirming a
message. The Signal LED will flash red until the
message is successfully transmitted or cancelled. If
the LED is flashing red, try moving to a new location
to get a better view of the satellites.
6
Using the inReach with a PN-60w
When you pair your inReach with the DeLorme Earthmate
PN-60w, you have the best of both worlds—a powerful,
rugged handheld GPS device and the ability to send and
receive messages wherever you go—whether you want
to share your trip, check in with loved ones, or send an
SOS in an emergency.