Publicidad
Idiomas disponibles
Idiomas disponibles
SCALE REMOVAL
Perform when the Clean Reminder glows red, before storage, or as needed. Failure to do so
may cause reduced or no mist output.
Prepare 4 cups/ 950 mL of a cleaning solution using a 50/50 mix of white vinegar and water.
1. Remove the tank cover
and pour out any water
from the tank and water
reservoir.
5. Pour out the solution
from the water tank and
water reservoir. Rinse
the water tank with
clean water until the
vinegar smell is gone
and wipe dry with a soft
cloth.
9. Pour a small amount of water in
the water reservoir, swish, and
pour out. Repeat until the vinegar
smell is gone. CAUTION: Never
submerge the base in water
on any other liquid.
2. Fill the tank with
4-cups/950 mL of 50/50
white vinegar and water.
Swish the solution around
the water tank. Do not
pour out the solution.
6. Remove the mist nozzle.
Clean using the solution
on a cotton swab. Rinse
with water to remove the
vinegar smell, dry and
set aside.
10. Completely dry all
parts with a soft cloth
before reassembling or
storage.
3. Place the tank on the
base. The solution will
drain into the water
reservoir and loosen
scale/water mineral
build-up.
7. Add a small amount of
solution to a soft cloth
or soft brush to clean
inside the mist tube.
Wipe with a damp, soft
cloth, or soft brush to
remove the vinegar
smell. Do not pour
water into the mist tube.
10
15'-20'
4. Soak for 15-20
minutes.
8. Wipe the transducer/
ultrasonic membrane
with a cotton swab to
remove loosened scale.
Wipe off with a damp
cotton swab. Never
touch the transducer/
ultrasonic membrane
with your fingers;
the natural oils in the
skin can damage the
surface. Brush the hinge
to remove any water
minerals.
Publicidad
