Publicidad
Idiomas disponibles
Idiomas disponibles
ABOUT WHITE DUST
Use of high mineral content hard water may cause a white mineral residue to accumulate
on surfaces in the room near the humidifier. The mineral residue is commonly called "white
dust." The higher the mineral content (or, the harder your water is), the greater the potential
for white dust. The white dust is not caused by a defect in the humidifier. It is caused only by
minerals suspended in the water.
HOW TO OPERATE
POWER BUTTON
Turns humidifier on/off.
WARM MIST
Press to turn warm mist on/off. The warm mist icon will illuminate on the display. Once
warm mist is selected, it will take 20-30 minutes to warm the mist.
TIMER
Press the timer
timer
button will cycle through the following settings: 2, 4, 8, 12, and 0 hours. To
cancel the timer at any time, press the timer
NOTE: Always be sure the humidifier has a full tank of water prior to using the timer setting.
NIGHT-LIGHT/DISPLAY LIGHTS
Press the night-light
of the humidifier will turn on. Press the button a second time to leave the night-light
on, but turn off display panel. Press the button a third time to turn off the night-light
and display panel. Press the night-light button a fourth time to turn the display lights on.
PROGRAMMING THE HUMIDITY LEVEL
The default humidistat setting is CO (continuous on). The programmable humidistat
can be set in 5% increments, from 35% to 55% humidity or continuous on.
The humidity level will increase by 5% each time the button is pressed and will be
displayed on screen.
NOTE: Humidifier will turn off when the set humidity level is reached. Humidifier will turn
on when the humidity level drops 5% below the set humidity level.
NOTE: To eliminate any programmed humidistat setting, continue to press the
programmable humidistat button until you reach CO, one level after 55%.
MIST OUTPUT
Mist adjusts from the lowest output (1) to the highest output (5). To increase the mist
output, press the mist output
display. Use the 360-degree rotating mist nozzle to adjust the mist output direction. Do
not point the mist nozzles toward walls or furniture.
button until the desired auto-shutoff timer setting is displayed. The
button once to turn on the night-light. The light at the bottom
button. The corresponding mist level will be lit on the
button until 0 hours is displayed.
7
Publicidad
