Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Before assembly, ensure to clean all parts that come into contact
with food with warm soapy water. For details, refer to section
"Cleaning, care & maintenance".
Blades are very sharp! Be careful when handling blades,
especially when emptying the bowl and during cleaning.
Rowlett accept no responsibility for any injury caused by incorrect
assembly/disassembly.
Mounting blender shaft
1. Align the arrow mark on the shaft with the Eject button on the
motor unit.
2. Insert the shaft into motor part until locked in place.
Mounting balloon whisk
1. Insert the balloon whisk into the attachment adapter.
2. Mount the adapter onto the motor unit.
Mounting chopper assembly
•
Always ensure the chopper bowl is in place before inserting the chopper blade.
•
Be sure the chopper lid is locked in place before operation.
1. Place the chopper bowl on a flat surface, then insert the chopper blade.
2. Add food in the bowl and locate the chopper lid.
3. Fix one end of the attachment adapter on the motor unit, then the other end on the chopper lid.
Operation
Blending
•
Lower the shaft or balloon whisk into food.
•
Connect the appliance to the power supply.
•
Press and hold the power button to start. If desired, use the speed selector to adjust the speed.
•
During operation, you can also press the "TURBO" button to run at the highest speed. In turbo
mode, do not let the motor run for more than 15 seconds.
•
After each use, release the power button or "TURBO" button to stop. Disconnect from power
supply and let attachments come to a full stop.
•
To remove the attachments, hold them with one hand and press the Eject button with the other
hand.
Max working time per cycle:
1 minute
Interval during cycles: 3 minutes
Caution:
Be careful of potential injury from misuse.
During use, never let the blending attachments face towards people or objects. Risk of
damage or injury!
It is recommended to tilt the bender slightly to prevent the blade guard from touching the
bottom of the container.
FB973_ML_A5_v2_20230925.indb 5
Beating/whisking
Max working time per cycle:
2 minutes
Interval during cycles: 10 minutes
Chopping
Max working time per cycle:
30 seconds
Interval during cycles: 10 minutes
2023/9/25 17:17:18
EN
5
Publicidad
