Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Timer indicator
light
Wireless operation
on indicator light
8
6
ON/OFF BUTTON
1.
Press to switch the dehumidifier on and off. The indicator light of the ON/OFF button remains lit when the appliance is
functioning and unlit when the appliance is off.
MODE BUTTON
2.
Press to select the desired operating mode:
STANDARD MODE: the appliance functions until the desired humidity level is reached.
CONTINUOUS MODE: the appliance functions at the maximum dehumidification level until the tank fills up.
control buttons are not enabled ('cont' indicator on).
AUTO MODE: the dehumidifier sets the relative humidity ( in a comfortable range 45%-55%) in relation to the ambient temperature
to maximise occupant comfort. in this mode humidity setting buttons are not enabled ('smd' indicator on)
LAUNDRY MODES: the dehumidifier fix the fan speed at high fan speed.In this mode, the '+' and ''control buttons are not enabled
('Dryer' indicator on).
3/4.
HUMIDITY SETTING BUTTONS
The desired relative humidity level can be set to between 35% (minimum) and 80% (maximum), with 5% increments each
time the '+' and '-' control buttons are pressed. When the set humidity level is reached, the compressor
The humidity setting buttons are disabled in the continuous
5.
FAN button
Press to select fan speed in three steps-low, med and high. The fan speed indicator light illuminates under different fan
speed settings, when select high fan speed, both the low and med fan speed lights illuminate.
6.
TIMER button
Press to set the start delay when the appliance is off, or the switch-off delay when it is on. The indicator light to the left of
the timer button will light up.
Press or hold the '+' and '-' control buttons to set the desired delay: 30 min (0.5 hours) increments occur between 0 and
10 hours, and 1-hour increments between 10 and 24 hours.
Restore the delay to 0.0 or switch off the appliance to cancel the timer function.
7.
DISPLAY
8.
WIRELESS button
Press the WIRELESS pad for 3 seconds to initiate the Wireless connection mode. The LED DISPLAY shows AP for 8 min to indi-
cate you can set Wireless connection.
AUTO-RESTART
This function enables the dehumidifier to restart, after a blackout, from the last stored settings.
ANTI-FROST FUNCTION
Prevents the evaporator from frosting, thereby extending the dehumidifier's life and enhancing energy saving. When this function is ac-
tive, the fan continues to turn while the compressor stops.
TANK FULL STOPPAGE
The dehumidifier stops when the condensate collection tank is full or incorrectly positioned. 'P2' will appear on the display
and the 'full' indicator light turns on.
IMPORTANT: When the compressor stops, it is necessary to wait 3 minutes before it restarts.
CAUTION
Do not touch the selector with wet hands (risk of personal injury due to electrocution).
Do not start or stop the appliance by simply plugging it into the power socket or unplugging it (risk of personal injury due to
electrocution).
Avoid prolonged direct exposure to the air flow (risk of personal injury due to sensitisation of the skin).
24
CONTROL PANEL
Fan speed
Bucket full
indicator light
indicator light
5
4
STANDARD,CONTINUOUS, AUTO or
only on NET
(available
models)
Continuous
7
operation on
indicator light
Dryer operation
on indicator light
3
LAUNDRY.
and auto
mode.
Smart dehumidifying
operation on
Unit operation
indicator light
indicator light
2
1
In this mode, the '+' and ''
stops.
Publicidad
