Royal Catering RCVG-47-1 Manual De Instrucciones página 19

EN
3.3. Device use
1. Vacuum bag selection
Select the appropriate size vacuum bag. Leave at least 2.5-5cm gap on each side of the bag, this will ensure
a better seal of the bag during sealing.
2. Connect the equipment to the power supply
The indicator LED on the control panel will indicate "OFF".
3. Turning the unit on
• Switch on the equipment with the ON/OFF button
• When the appliance lid is open, the LED display will show the vacuum sealing or air extraction time.
• Place the food vacuum bag directly into the vacuum chamber and close the lid.
The appliance will operate automatically.
Caution! When "CLO" appears on the LED display, the unit is in a protected state. In this state, no matter
which button is pressed, the appliance will not operate. Open the unit's cover and the unit will return to
normal operation.
4. Adjusting/setting the time control
The air extraction time:
Keep the cover open, press the SET button and make sure the air extraction time light is on.
Use the "Ʌ" or "V" buttons to increase or decrease the air extraction time. For the first air extraction test,
set the time to 30 seconds. Adjust the air extraction time to suit your needs. The time range is from 5 to 90
seconds.
Vacuum sealing time:
Hold the lid open, press the SET button and make sure the vacuum seal time indicator light is on.
Use the "Ʌ" or "V" buttons to increase or decrease the vacuum seal time.
For the first air extraction test, set the time to 5 seconds. Adjust the vacuum sealing time to suit your
needs.
The time range is from 0 to 6 seconds.
Caution! All time adjustments, must be done with the appliance switched on
and the appliance lid open.
5. Placing the bag
• Keep the bag containing the liquid below the height of the sealing bar
• Insert the bag into the vacuum chamber and make sure that the opening of the bag extends beyond the
sealing bar
Caution! The entire bag, including the holes, must be inside the vacuum chamber.
6. Suction and vacuum sealing process
• Close the lid of the appliance. The appliance automatically performs air extraction and vacuum sealing.
• After closing the lid, the appliance will automatically start the air extraction and vacuum sealing process,
the number on the LED display will count down from the set value (air extraction time, then vacuum
sealing time) to 0.
• The air is extracted from the bag. You may notice that the bag is tightening around the product.
• When the machine beeps, the machine cycle is complete.
7. Checking
After each sealing operation, check that the sealing has been done correctly. If there are leaks or creases in
the sealing area, extend the sealing time by 5 seconds and repeat the cycle. The welding spot should be
clean.