Publicidad
aTTach The BuLKheaD To The BLaDe
MounT aSSeMBLY
STeP 5:
(See FIGure 5)
• Insert the pivot shaft (8) through the two sets of pivot
brackets (5) of the blade mount assembly (7). For
now, use the 5th hole from the top in each side of the
bulkhead (9).
• Secure each end of the pivot shaft (8) using a
washer (Y) and a hair cotter pin (K).
note: For final height adjustments go to page 12.
K
5
7
9
8
Y
K
FIGure 5
aTTach PuSh TuBeS To The BuLKheaD
STeP 6:
(See FIGure 6)
• With a push tube (1) level to the hitch mount assembly
(6), insert the end of the push tube into the 9th hole
from the top of the bulkhead (9) for now.
• Repeat with the second push tube (1).
• Secure each push tube (1) to the bulkhead (9) using a
washer (Y) and hair cotter pin (K).
Y
1
8
9
K
1
6
FIGure 6
Y
K
1
Publicidad
