Publicidad
Idiomas disponibles
Idiomas disponibles
CARS, BOATS AND MOTORBIKES
Rinse the surface to be cleaned and the surrounding area with fresh
ES
water. If using detergent, fill the detergent tank and apply to the area
to be cleaned at low pressure. For best results, clean one side at a
time. Let the detergent sit on the surface for a few minutes, but do
not allow it to dry. Rinse at high pressure using the fan sprayer in a
PT
sweeping motion keeping the tip of the spray nozzle at least 20cm from
the cleaning surface. Maintain a greater distance from the cleaning area
when using a direct spray. Wipe the surface dry with a cloth to obtain
a polished finish.
EN
BARBECUE GRILLS, ELECTRICAL EQUIPMENT AND GARDEN
TOOLS
Rinse the surface to be cleaned and the surrounding area with fresh
FR
water. If using detergent, fill the detergent tank and apply to the
area to be cleaned under low pressure. Let the detergent sit on the
surface for a few minutes, but do not allow it to dry. Rinse at high
pressure using the fan sprayer keeping the tip of the spray nozzle
at least 2-8cm from the surface to be cleaned. Keep a greater
distance from the cleaning area when using a straight sprayer.
TECHNICAL DATA
Reference
Mains voltage
Mains frequency
Power
Nominal pressure
Max. pressure
Nominal flow
Max. water inlet pressure
Max. water inlet temperature
Sound pressure level measured according to ISO 3744:
LPA (sound pressure) dB (A)
KPA (sound pressure) dB (A)
LWA (sound power level) dB (A)
K WA (sound power) dB (A)
Weighted root mean square acceleration
value:
WARRANTY
EDM guarantees all its products and declines all responsibility for
damage caused by incorrect installation / use of its products. This
Instruction manual
warranty applies only if the instructions for use have been followed, and
is void if the appliance has been tampered with or used in an improper
and inadequate manner, or if it has been repaired by an unauthorised
person.
ENVIRONMENT
If you need to replace your machine after prolonged use, do not throw
it in the household waste, but dispose of it in an environmentally safe
manner.
HOW TO TROUBLE
THE SWITCH IS IN THE "I" POSITION BUT THE MACHINE WILL
NOT START
▶The socket is defective.
▶The voltage is inadequate.
▶The power cable is not plugged in.
PUMP DOES NOT REACH ADEQUATE PRESSURE OR
FLUCTUATES
08470
▶Water inlet filter is clogged.
230V
▶Pump is sucking air.
50Hz
1200W
▶Suction valves are clogged/worn.
60bar
▶Garden hose diameter is too small.
90bar
330 L/h
▶Water supply is restricted.
12bar
50°C
PRESSURE WASHER HAS OR WILL NOT HOLD PRESSURE
▶Excess air in water line and pump.
90,3
3
PRESSURE WASHER IS MAKING EXCESSIVE NOISE
105
▶Intake is blocked.
3
< 2,65 m/s
▶Valves are worn, dirty or clogged.
2
▶Filter is dirty.
ENGINE STOPS RUNNING WHILE IN USE
▶Net voltage lower than suggested.
24
Check the plug, socket and fuses.
Check for proper voltage.
Connect the power cable.
Remove and clean the filter
Tighten connections/purge system.
Clean or replace valves.
Replace with 3/4" garden hose.
Check hose for kinks or leaks. The water supply tap is not fully open.
Turn off unit and water supply. Flush the system by holding down
the trigger.
Check intake valves.
Check, clean or replace valves.
Check, clean or replace the filter.
Check for proper voltage.
ref. 08470
Publicidad
