Milwaukee 2735-20 Manual Del Operador página 3

SYMBOLOGY
Volts
Direct Current
Read Operator's Manual
UL Listing for Canada and U.S.
SPECIFICATIONS
Cat. No. ..................................................... 2735-20
Volts.............................................................. 18 DC
Battery Type .................................................M18™
Charger Type................................................M18™
Cat. No. ................................................ 49-24-0146
Volts.............................................................. 12 DC
Battery Type .................................................M12™
Charger Type................................................M12™
Recommended Ambient
Operating Temperature .................... 0°F to 125°F
FUNCTIONAL DESCRIPTION
1
2
3
4
1. Bezel assembly
2. Pivot head
3. Magnet
4. On/Off button
5. Hook
2
5
4
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove the battery pack
WARNING
any time the tool is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
To reduce the risk of injury, do not
WARNING
stare at the operating light source.
Adjusting the Pivot Head
The pivot head can pivot to a range of 90°; with
detents every 15° (every 10° for the 2735-20). Pivot
head to desired position. Allow the detent to snap
into place. Do not forcibly pivot the head.
To reduce the risk of injury, do not
WARNING
operate work light without bezel
assembly in place.
NOTE: The LED bulb cannot be replaced. Bezel can
not be removed. Attempting to remove the bezel will
damage tool.
3