Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.
OPERATION
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
APPLICATIONS
You may use this product for the purposes listed below:
Numerous applications are available depending upon the
accessory head installed
OVERLOAD PROTECTION
When the tool is forced or the motor is overloaded, the power
base will automatically shut off. To reset the tool, release the
trigger and resume operation. Do not force the tool.
HIGH TEMPERATURE PROTECTION
The power base is equipped with a high temperature protec-
tion feature that deactivates the tool when it is overheated.
When the tool or battery overheats, the tool will automatically
shut off. To resume operation, allow the tool to cool and then
squeeze the trigger.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
LED GRIP LIGHT
See Figure 1, page 8.
The LED light located above the switch trigger, illuminates
when either the switch trigger or grip light switch is
depressed.
VARIABLE SPEED SWITCH TRIGGER
See Figure 1, page 8.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the tool ON, depress the switch trigger. To turn it
OFF, release the switch trigger and allow the tool to come
to a complete stop. The trigger will not operate the power
base unless an accessory head is attached.
NOTE: A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
See Figure 1, page 8.
Set the direction of rotation selector in the OFF (center
lock) position to lock the switch trigger and help prevent
accidental starting when not in use.
Position the direction of rotation selector to the left of the
switch trigger for forward movement. Position the selector
to the right of the switch trigger to reverse the direction.
NOTE: The tool will not run unless the direction of rotation
selector is pushed fully to the left or right.
NOTICE:
To prevent gear damage, always allow the tool
to come to a complete stop before changing the
direction of rotation.
5 - English
Publicidad
