BOMANN SM 401 CB Instrucciones De Servicio página 28

Instructions for use
• Chop up large pieces of solid food before mashing (max. Ø
1.5 cm) and add a little liquid.
• Short-time operating: Do not operate the appliance
longer than 1 minute continuously. Leave the device to cool
down for at least 5 minutes before using again.
Assembly / Dismantling
WARNING: Risk of injury!
When attaching accessories there is the risk of pinching
your fingers. Please be especially careful.
Observe additional Figure on page 3. Assemble the motor
housing and the hand blender as follows:
1. Press both buttons (5) simultaneously.
2. Attach the motor casing (4) on the
blender (6) until it clicks into place.
Observe the recesses on the blender.
3. Release the buttons. Motor casing and
blender are tightly connected.
To detach press and hold both buttons simultaneously and
pull the blender from the motor casing.
Electrical connection
1. Ensure that your mains power corresponds with the speci-
fications of the appliance. The specifications are printed
on the type label.
2. Connect the mains cable to a properly installed and
earthed wall outlet.
WARNING:
• Always remove the plug before cleaning.
• Under no circumstances should you immerse the motor housing in
water in order to clean it. Otherwise this might result in an electric
shock or fire.
• The blade of the bar mixer is very sharp! Please be very careful.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
NOTE:
Fill a container with hot water and let the blender run in it
for pre-cleaning as described under "Operation".
28
SM401CB_IM
WARNING:
When using the appliance in hot foods, there is a risk of
burning due to hot splashing.
1. Submerge the entire blender head in foodstuff or bever-
age. Keep the appliance upright. In this way you avoid
spatters.
2. Hold the grip with one hand in such way that you can
press one of the push buttons (I or TURBO) at the same
time.
• Push button I (2):
This switches on the minimum speed.
• Push button TURBO (3):
This provides the maximum speed and cannot be
regulated.
3. Pulsed mode is switched on by pressing the appropriate
push button at intervals and then releasing it again.
4. The device switches itself off when the button is released.
WARNING: Risk of injury!
The motor overtravels. Wait until the knife comes to a
complete standstill.
NOTE:
Interrupt the process if the maximum speed is too slow.
Reduce the quantity of the food being mixed. First break
up any solid food.
5. Pull out the plug from the socket after use.
6. After cleaning hang the appliance on its eyelet (1).
Cleaning
• Wipe the casing with a damp cloth.
• If you want to clean the hand blender (mixing rod) thor-
oughly, detach it from the motor housing as described
under "Assembly / Dismantling".
Operation
14.12.15