Publicidad
Idiomas disponibles
Idiomas disponibles
4B
4. Attach the display to the mounting bracket
assembly by hooking bottom spring hook and
then pushing up and hooking top hooks. (FIG. J)
5. Determine the desired position of the display:
a. Display can be vertical or tilted up. (FIG. K)
b. Display can slide up or down. (Page 7)
c. Display can be tilted horizontally. (Page 7 – FIG. B)
6. Determine the final front to back position by
measuring the shortest distance between the
display to the dash kit main frame or the factory
dash and subtract that distance/measurement by
~0.25".
Note: Do not push the display all the way up
against the dash. Leave enough bottom gap as
the display's bottom edge rotates towards the
dash.
7. Remove the display from the bracket
assembly by pushing up from compression
spring side (1) and swing out to unhook top (2).
(FIG. L)
8. Remove the radio module & mounting
bracket assembly from the vehicle. Using the
measurement taken in step 6, slide the radio
module & bracket assembly back to that
distance.
PROCEED TO STEP 5
on Page 16
FIG. J
HOOK BOTTOM
FIRST, THEN TOP
NOTE: BOOT AND DASH KIT NOT SHOWN
FIG. K
B
M5 X 10
VERTICAL TILT: Use Hole A for no vertical
tilt or Hole B for 8 degrees of vertical tilt.
Insert a M5 X 10 on each side of the clamp
assembly at desired tilt.
2
1
M5 X 10
A
FIG. L
Compression Spring
11
Publicidad
