Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Before starting installation, please read the entire manual carefully and save for future reference.
Decide on the mode for the strobe. Because there are so many combinations, you may want to
connect to a 12~24 VDC power supply and experiment to get the effect you desire.
NOTE:
Disconnect power before changing DIP switches/jumpers to avoid damage to the device.
In Power-On Mode, only the two power leads are
used with a single trigger. The strobe lights in a
single color, either flashing or steady on; a single
color, steady on; or alternating colors flashing.
Trigger Mode allows up to three triggers so different
colors can indicate different situations. It also allows
various color combinations and either flashing or
steady on.
1. Unscrew the strobe light lens and set aside.
2. For direct mounting to a flat surface:
a. Determine the location and, using the base as
a template, mark the holes for mounting and
wiring. Drill two
b. Drill a wiring hole if wires will be concealed,
ensuring that the wiring hole is sufficiently
large for the wires and their connectors to
easily fit through without dislodging the
connections. For surface wiring, remove the
thinned-out slot with a pair of pliers (see
Overview, pg. 4). Skip to step 4.
3. For mounting to a conduit box/drop (see Fig. 1).
a. Thread the wires through the adapter plate,
gasket, and strobe base.
4. Mount the plate to the conduit box/drop with the
short screws included with the conduit box/drop.
5. Connect wires based on your chosen mode and
colors.
SECO-LARM U.S.A., Inc.
/
" (2.3mm) mounting holes.
1
16
Multi-Color LED Strobe Light
Fig. 1
Conduit drop (optional)
Conduit box (optional)
Adapter plate (optional)
Threaded hole
Rubber gasket (optional)
Note gasket orientation
Strobe light base
(Use two larger holes
extending through base)
Circuit board
Long screws (included)
Strobe light lens
5
Publicidad
