GLO hyper pro Manual Del Usuario página 3

QUICK START
4
Please refer to the device diagram on the first page.
To open the heating chamber
1
1
heating mode, simply rotate the dial
counterclockwise.
EN
When the dial marker aligns with the symbol, it
2
GR
means the Standard mode is selected. When it
aligns with the
selected.
PT
Insert the stick into the heating chamber
3
ES
Press and hold the control button
seconds to start pre-heating. To activate the
device before the first use, you may need to hold
the control button for 3 seconds.
You'll feel a vibration, which means the pre-heating
4
process has begun. The display
the countdown before the start of the session.
Another vibration will indicate when the device is
ready for use.
5 Lift the product with the stick inserted into it and
inhale gently.
The device will vibrate to signal the end of the
6
session. You can terminate your session earlier by
pressing the control button
Once the session is complete, remove the stick
7
from the device and dispose of it responsibly
Finally, rotate the dial
8
heating chamber.
and choose the
1
2
symbol, the Boost mode is
.
1
for 2
3
4 will show the
3 for 2 seconds.
clockwise to close the
2
CHARGING
Before the first use, charge the device in line with the
safety instructions using USB-C charging port
CLEANING
Ensure the product has been allowed to
cool for a minimum of 10 minutes before
cleaning.
After every 5 sessions, open the cleaning door
use a tissue to wipe away any moisture.
After every 20 sessions, open both the heating chamber
and the cleaning door
1
provided to clean the heating chamber from both ends.
Rinse the brush under running water and allow to dry
before using it again.
RESTART
If necessary, you can reset the device to its default
settings by following these steps:
1. Ensure that the dial
2 is in the "OFF" position.
2. Press and hold the control button
seconds.
For more information and troubleshooting, please refer to
the online guide (scan the code below).
5
6 and
6 and use the brush
3 for about 22
5
EN
GR
PT
ES