Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
LOADING FASTENERS
A fastener can be driven unintentionally if the trigger and safety
bracket are activated at the same time. Always disconnect tool
from air supply before loading fasteners, making adjustments, or
performing any service on tool. Keep finger off trigger until ready
to drive a fastener.
LOADING INSTRUCTIONS
1. Pull pusher (A) back to latched
position at rear of magazine.
2. Insert nail strip (B) into rear of
magazine, and allow nails to
slide forward, toward tool nose.
3. Pull pusher (A) back and press
release lever (C) to release latch,
and slide pusher forward
against nail strips.
4. Tool is now loaded and ready to
be connected to an air supply
for operation.
CLEARING NAIL JAMS
1. Disconnect tool from air supply
using quick-connect coupling.
2. Pull pusher back to latched
position at rear of magazine.
3. Open E-Z Clear latch and open door.
4. Remove jammed fastener.
5. Close door and secure with latch.
6. Release pusher and slide
forward against nail strips.
7. Connect air supply and check
tool for normal operation.
DANGER
10
Publicidad
