Publicidad
Idiomas disponibles
Idiomas disponibles
Government Regulations
This device complies with Part 15 of FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesirable operation.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates and
can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to
radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television, which can be determined by turning
the equipment OFF and ON, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•
Consult the dealer or an experienced radio / TV technician for help.
Remote Controls
To satisfy FCC RF exposure compliance requirements, this device should
10
© 2019 Directed. All rights reserved.
be used in hand-held, hand operated configurations only. The device and
its antenna must maintain a separation distance of 20 cm or more from
the person's body, except for the hand and wrists, to satisfy RF exposure
compliance. This device is designed to be used in a person's hands and
its operating configurations do not support normal transmissions while it is
carried in pockets or holsters next to a person's body.
Control Center
To satisfy FCC RF exposure compliance requirements, the device and
its antenna must maintain a separation distance of 20 cm or more from
the person's body, except for the hand and wrists, to satisfy RF exposure
compliance.
This device complies with the Industry Canada Radio Standards
Specification RSS 210. Its use is authorized only on a no-interference,
no-protection basis; in other words, this device must not be used if it is
determined that it causes harmful interference to services authorized by
IC. In addition, the user of this device must accept any radio interference
that may be received, even if this interference could affect the operation
of the device.
WARNING!
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this device.
© 2019 Directed. All rights reserved.
11
Publicidad
