Publicidad
Idiomas disponibles
Idiomas disponibles
LED FUNCTIONS
OF CHARGER
LED WILL BE ON TO INDICATE
STATUS
OF
CHARGER
AND BATTERY
PACK:
•
Red LED on = Fast charging mode.
•
Green LED on = Fully charged and in trickle
charge mode.
•
Green LED on = When battery pack is inserted
into charger, indicates hot battery pack or that
battery pack is out of or below normal temperature
range,
•
Yellow and Green LEDs on = Deeply discharged
or defective battery pack,
•
No LED on = Defective charger or battery pack,
_
CAUTION:
To prevent damage to battery pack,
remove battery pack from charger immediately if
no LED comes on. Return battery pack and
charger to your nearest Sears Service Center for
checking or replacing. Also, if you are removing
battery pack from charger and no LEDs are on,
return both battery pack and charger to your
nearest Sears Service Center. Do not insert
another battery pack into charger. A damaged
charger may damage a battery pack.
TO INSTALL/REMOVE
BATTERY
PACK
See Figure 2.
•
Use only the recommended battery pack with your
worklight.
_,
WARNING:
Do not install battery pack to your
worklight until you have read and understood all
precautions and operating instructions in the
manual and printed on battery pack and charger.
•
Orient battery pack so that raised rib on battery
pack aligns with groove inside worklight. Battery
pack is designed to fit only one way in worklight
handle.
•
Insert battery pack, making sure latches on each
side of battery pack snap into place and battery
pack is secure in worklight before use.
CAUTION:
When placing battery pack in your
worklight, be sure raised rib on battery pack
aligns with groove inside worklight handle and
latches snap into place properly. Improper
assembly of battery pack can cause damage to
internal components.
•
To remove battery pack, locate latches on end of
battery pack and depress to release battery pack
from your worklight.
SWITCH
See Figure 3.
To turn your worklight on and off, depress switch
trigger.
MULTI-POSITION
HEAD
See Figure 3.
Your worklight has the feature of a multi-position head
that has positive stop clicks at each position. Rotate
head to the desired position as shown in the arrows in
Figure 3.
MULTI-POSITION
SWITCH
TRIGGER
BATTERY
PACK
LATCHES
Fig. 3
LATCHESTO
RELEASEBATTERYPACK
Fig. 2
5
Publicidad
