Digital Multibandradio - Use instructions
DESCRIPTION Fig. 1
1 Telescopic antenna
2 MODE button
3 SET button
4 TUNING control
5 VOLUME control
6 LCD display
7 POWER ON/OFF selector
8 Loudspeaker
9 SW Frequency range selector
Back side, not shown in the figure
Battery holder
Start-up of the device/Introduction
• Select a suitable location for the radio recorder, such as a dry, flat, non-
slip surface on which it is easy to operate the machine.
• Ensure that the radio recorder is sufficiently ventilated!
Inserting the Batteries (not supplied)
• Open the lid of the battery compartment on the back.
• Insert 2 batteries of type AAA/R03 1.5 V. Match the polarities correctly
(see the inside of the battery compartment)!
• Close the battery compartment again.
• If the device is not used for a long period of time, remove the batteries to
avoid the "spilling" of battery acid.
Different battery types or new and used batteries must not be used to-
gether.
• Batteries are not to be disposed of together with domestic wastes. Dispo-
se of the used batteries at the relevant collection bin or at your dealer's.
WARNING:
Do not expose the batteries to high temperatures or direct sunlight. Never
throw batteries into the fire. There is a danger of explosion!
Configuring the settings
Configure all settings with the MODE button. Change the currently se-
lected mode with the SET button
NOTE:
Push the SET button during the time display to show the following settings:
Set alarm time, date, and seconds. If you push the MODE button while the
seconds are shown, you can reset it to zero.
11