Segway-Ninebot eKickScooter E2 Pro Manual Del Producto página 5

EN
Common Failures
5
Error code Possible causes and solution
10 Dashboard communication is abnormal, please check the dashboard or related cables.
11 Phase A of motor current sampling is abnormal, please check controller.
12 Phase B of motor current sampling is abnormal, please check controller.
13 Phase C of motor current sampling is abnormal, please check controller.
14 Throttle hall sensor error, please check throttle handle, dashboard and related cables.
Brake hall sensor error, please check brake handle, dashboard and related cables.
15
The motor Hall sensor is abnormal, please check the controller.
18
Battery communication error, please check the controller.
21
The battery is the default serial number, please contact after-sales service.
23
35 Serial no of the scooter is wrong, please contact after-sales service.
Battery temperature sensor is abnormal, please make sure the temperature is between 14°F (-10°C)
39
and 122°F (50°C), or contact after-sales service.
Motor not calibrated,please contact after-sales service.
42
The motor bus current amplifier circuit is abnormal. Please contact after-sales service.
45
Motor phase loss, please check controller.
50
Controller over voltage, check if the vehicle charger is used or if the vehicle is restarted.
51
The motor is stalled, please check whether it is overloaded.
52
The controller is over current, please check whether it is overloaded.
53
The controller is over current level II, please check whether it is overloaded.
54
07
Wiring Diagram
6
Buzzer
Key
Display
MCU
Cell BMS
Battery
Current
Sampling
Turnlight Turn Signal Swich
Accelerator
Bluetooth
Headlight
Module
Brake
Dashboard
Tail light
Temperature Sensor
Hall Sensor
U
V
Motor driver
W
Control
EN
Motor
08