Publicidad
Idiomas disponibles
Idiomas disponibles
6. Remove the belt a sfollows. Refer toFigure 25.
a. Loosen and remove the shoulder screw w hich a cts a sabelt
keeper.
b. Unhook the support bracket spring f rom the frame.
7. Remove
the belt f rom around the auger pulley, and slip the belt
between thesupport bracket and the auger pulley. See Figure 26.
8. Reassemble
auger belt b yfollowing instructions
inreverse order.
9. Perform t he Auger Control test o utlined inthe Assembly
section
ofthis manual.
NOTE: DoNOT f orget toreinstall the shoulder screw and reconnect
the spring tothe frame a fter i nstalling
areplacement
auger belt.
Drive Belt
Toremoveand replaceyoursnow thrower'sdrivebelt, proceedas
follows:
1.
Topreventspillage,removeall fuel fromtank by runningengine
untilit stops.
2.
Removetheplasticbelt coveron the front of the engineby remov-
ing the two self-tappingscrews.See Figure22 on previouspage.
3.
Removethebelt as follows.Referto Figure27.
a.
Rollthe auger beltoff theengine pulley.
b.
Use a wrenchto pivotthe idlerpulleytowardthe right.
c.
Lift the drivebelt off enginepulley.
/"
}
Figure25
Figure26
21
Figure27
Publicidad
