Getting Started - Texas Instruments TI-5006 II Manual De Instrucciones

Getting Started

Installing the AC Adapter
1. Press V.
2. Connect the adapter cord to the socket on the back of the calculator.
3. Plug the adapter into an electrical outlet.
Using any AC adapter other than the appropriate TI adapter
Warning
may damage the calculator and void the warranty.
Installing or Replacing Batteries
1. Press V. Unplug any connected AC adapter.
2. Remove the battery compartment cover from the bottom of the
calculator.
3. If necessary, remove the old batteries.
4. Insert new batteries in the compartment as shown in the diagram
inside the battery compartment.
5. Replace the battery compartment cover.
Installing the Paper Roll
Caution: Avoid placing a double thickness of paper into the mechanism.
Do not pull the paper through the mechanism without pressing &.
1. If necessary, press G to turn the calculator on, and press S
to turn the PRINT display indicator off.
2. Remove the printer compartment cover by placing a thumb on each
of the lower ridged corners of the cover. Push until the cover pops
open, and lift the cover off.
3. Go to Page 2 and follow the instructions for the size of the paper roll.
1