Publicidad
Idiomas disponibles
Idiomas disponibles
Wireless Pairing
1. Once T306 has been turned ON – hold down the pairing button
blue (to indicate headset is ready for Wireless pairing)
2. Enable Bluetooth function on your electronic device.
3. Search Bluetooth signal Spector T306 & pair your device (Blue LED will flash slowly when
the T306 is paired)
4. To DISCONNECT from Wireless mode: press & hold
Wireless Mode
1. Play/Pause/Answer & End calll: press
2. Reject incoming call: press & hold
3. Redial last outgoing call: double press
4. Volume control: quick press +/- buttons
5. Skip songs: press & hold +/- buttons
NOTE: If the T306 is powered ON & connected but not used for 10 minutes consecutively, the
headset will enter in Sleep Mode (power saving mode). Press
Voice Dialling
Note: the voice activation feature on your connected device must be enabled/activated in order for it
to work using the T306
1. Press & hold the
dialing is activate
2. Say whom you would like to call & your phone will begin dialing the number.
Aux Mode
1. NOTE: T306 does NOT require battery power when in AUX Mode (keep headset OFF in Aux
mode in order to preserve the battery)
2. Plug in 3.5mm AUX audio cable into the T306 & into your audio device
3. Play/Pause/Skip Songs/Volume Control/Answer & End Calls: must be controlled directly on
your audio device
ANC Activation
1. To activate Active Noise Cancelling feature (in Wireless or in Aux Mode) - slide the ANC
power switch (White LED will remain lit to indicate ANC mode)
To Charge the T306
1. Insert micro USB into the T306 & connect the USB output to a wall adapter (not included)
2. Red LED indicates the device is charging (Red LED will turn off once fully charged)
3. Low battery indicator: flashing red LED & an audio alarm will prompt you to recharge the
headset when the battery is low.
button for a few
seconds until you hear a "beep" sound which indicates voice
(c)
until LED flashes red &
(c)
until LED flashes red & blue again.
to start using T306 again.
Publicidad
