CONTROL ELEMENTS
Control elements - one and two zones
The control panel is shown in Figure 5. It is also shown below:
Single zone
Two zones
Press
to turn on the appliance. Press and hold the button for 3 seconds to turn off
the appliance.
Note: It will take about 3 seconds for all LED displays to turn off.**
Press
to turn the interior LED lighting on/off. Interior lighting is not controlled by
opening and closing the door.
To reduce energy consumption, LED lighting will turn off automatically after 3-4 sec-
onds.*
If you want the interior lighting to remain on, press and hold
display will show "LP". After 4 seconds, the display will show the temperature again
and the light will be on until it is switched off again. Press and hold
to set the light is to switch off automatically after few seconds (recommended), The
display will show "LF". After 4 seconds, the display will show the temperature again
and the light will be on for only 3-4 seconds.
Set the temperature — single-zone refrigerator
Press to increase the temperature in the chamber by 1°C*.
Press to decrease the temperature in the chamber by 1°C*
•
The range of temperature that can be set varies between 5°C and 20°C.
•
The optimal temperature for wine storage is 12°C.
•
To check the current temperature inside the chamber, press and hold or for 3
seconds and the display will show the current temperature. After 5 seconds, the
34
for 5 seconds — the
for 5 seconds