Publicidad
Idiomas disponibles
Idiomas disponibles
LIGHT FUNCTION
EN
• Turn on the light
To turn on the light for ten
minutes, press the light
button. To turn the light off,
press the button again.
• Turn on waking up with light
To turn on the light when the
alarm goes off, use a long
press on the light button
for at least two seconds.
Then the light will turn on.
To turn the light on and off,
rotate the main knob. To save
changes, use a long press on
the button again. Changes
will automatically be saved
after five seconds without
interaction.
• Adjust light intensity
While the light is on, rotate
the main button to increase or
decrease the light intensity.
TIMER FUNCTION
To set the timer, press the
timer button. Each press adds
15 minutes to the timer. The
maximum time that can be
counted down is 60 minutes.
The timer will automatically
start after the sound
confirmation. When the timer
goes off, it will be indicated by
another sound.
LOW BATTERY WARNING
4
When the battery level is at
less than 5%, a low battery
level warning will be activated.
When the battery is critically
low, any interaction with
the alarm clock will trigger
the lights to flash and a low
battery-level warning to
sound. Functionalities are
limited to time indication
and alarm functionality. The
device should be plugged in
and charged immediately.
Otherwise, its battery will be
completely discharged, and
the quartz mechanism will
stop functioning.
BATTERY LEVEL CHECK
To check the battery level,
deep press and hold the main
button for at least 2 seconds.
Then, a light flash and sound
will indicate the current
battery level.
CHARGING
To charge the device,
plug in a USB-C cable. The
recommended power supply
is 5V DC. Charging from 5% to
100% of the battery may take
approximately five hours.
FACTORY RESET
To reset the device, press
the timer and light buttons
simultaneously, for 5 seconds.
Release when you hear a
ringing sound, and the light
turns off.
WARRANTY
For information about the
consumer warranty, please
refer to Mudita's website:
mudita.com.
SAFETY AND USE
We recommend that you read
this section very carefully
before using the alarm clock.
The manufacturer disclaims
any liability for damage, which
may result as a consequence
of improper use or use
contrary to the instructions
contained herein.
CHARGING SAFETY
This alarm clock must be used
with an AC power adapter
that has been certified with
a Limited Power Source output
per IEC 60950-1/62368-1 rated:
5 Volts DC, maximum 1.5 Amps.
BATTERY SAFETY
The lithium-ion battery in this
device should be serviced only
by the manufacturer (Mudita),
and must be recycled or
disposed of separately from
household waste. Dispose of
batteries according to your
local environmental laws and
guidelines.
REGULATORY INFORMATION
Publicidad
