Parkside PHP 500 D2 Traduccion Del Manual De Instrucciones Originale página 24

and are aware of the potential
risks . Children must not play with
the appliance . Cleaning and user
maintenance tasks may not be car-
ried out by children unless they are
supervised .
■ To avoid potential risks, damaged mains cables
should be replaced by the manufacturer, their
customer service department or a similarly
qualified person .
Additional safety instructions for
glue guns
■ Children should be supervised to ensure that
they do not play with the appliance .
■ CAUTION! This appliance must be placed on
its stand when not in use .
■ Always protect the appliance from rain and
moisture . Water entering a power tool will
increase the risk of electric shock .
■ Do not misuse the power cord, e .g . to carry
or hang up the appliance, or to pull the plug
from the socket . Keep cord away from heat,
oil, sharp edges or moving parts . If the power
cord is damaged or severed during work, do
not touch the cord but rather pull out the power
plug . Damaged or entangled cords increase the
risk of electric shock .
■ Only for indoor use .
■ If you take a break of longer than 30 minutes,
pull out the power plug .
■ Allow the appliance to cool completely after
use and before storage .
■ Do not work on any material containing asbestos .
■ Avoid the risk of injury or fire as well as health
risks: RISK OF BURNS! The adhesive and the
nozzle reach a temperature of around 200°C . Do
not touch the nozzle or the glue . Do not allow hot
glue to come into contact with people or animals .
In case of contact with skin, rinse the affected part
in cold running water for a few minutes . Do not
attempt to remove the adhesive from the skin .
■ Always route the power cable towards the rear,
away from the appliance .
PHP 500 D2
■ Do not pull back the glue stick!
Cut it off to store the device in the
carrying case .
Operation
Before use
Preparing the surfaces to be glued:
■ Do not use flammable solvents to clean the
surfaces to be glued .
■ The ambient temperature and the materials to
be bonded may not be colder than 5°C and
not warmer than 50°C .
■ The area to be glued must be clean, dry and
free of grease .
♦ Smooth surfaces should be roughened before
gluing .
♦ Quick-cooling materials such as steel should be
warmed a little to facilitate adhesion .
♦ Select the desired nozzle
Using the appliance
Mains operation:
♦ Connect the power cable
connection of the glue gun
the power plug into the socket .
♦ Fold down the plastic stand
appliance .
♦ Push a glue stick into the feeder shaft
♦ Allow the appliance to heat up for about
5 minutes . The appliance is now ready for use .
Battery operation:
♦ Connect the power cable
connection of the charger
plug into the socket .
♦ Place the glue gun into the charger
♦ Push a glue stick into the feeder shaft
♦ Allow the appliance to heat up for about
5 minutes . The appliance is now ready for use .
♦ Repeat the heating phase if the glue is still too
thick or viscous .
.
to the mains
(see fig . B) . Insert
. Put down the
.
to the mains
. Insert the power
.
.
GB │ MT │ 21 ■