Whispbar K1005W Instrucciones De Montaje página 9

EN
Fitting Kit
K1005W
Fitment
Clamps directly to edge of roof under the
doors, pin located in hole on vehicle.
Please check the front of this manual for
information relating specifically to your
vehicle.
Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
Adjust the legs on the crossbar so that they
are positioned equally from the ends of the
crossbar, and the clamps engage firmly on
the body work of the vehicle.
Locate vehicle's fixed points.
Ensure the clamp pin is inserted into the
fixed point and the clamp sits flat to the
body side.
Tighten adjusting screw to 2 Nm (1.5 ft lb)
hand tight.
9