CLEANING AND MAINTENANCE
CLEANING
Do not use abrasive cleaning agents or solvents.
1.
Set the temperature control knob to the "0" position and disconnect the mains plug from
the mains socket.
2.
Take out the food and store in a cool location.
3.
Clean the appliance with a soft cloth, warm water and detergent.
4.
Wipe the door seal with clear water only and then wipe dry thoroughly.
5.
After cleaning reconnect and adjust the temperature control knob as desired.
6.
Put the food back into the appliance.
DEFROSTING THE FREEZER
A layer of frost in the freezer will impair refrigeration of the frozen food and increases power
consumption. Remove the layer of frost regularly. Do not scrape off frost or ice with a knife or
pointed object. Doing this may damage the refrigerant tubes.
1.
Remove the frozen food and place temporarily in a cool location.
2.
Disconnect the appliance from the mains socket.
3.
To accelerate the defrosting process, place a pan of hot water on a stand in the freezer.
4.
Wipe up condensation with a cloth or sponge.
5.
Wipe dry the freezer compartment.
6.
Plug in the appliance and adjust the temperature control knob as desired.
7.
Put the frozen food back in the freezer.
BULB REPLACEMENT
1.
Set the temperature to '0'. Unplug the appliance from the power supply before replacing
the light bulb.
2.
Remove the bulb cover.
3.
Unscrew the old bulb and then screw a new bulb.
4.
Replace the bulb cover. Now close the appliance.
MOVING YOUR APPLIANCE
If the appliance is turned off for any reason, wait for 12 hours before turning it back on. This
will allow the refrigeration system pressures to equalise before restarting.
· Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove
all mobile parts (shelves, accessories, etc.) or fix them into the fridge to avoid any shock.
· Relocate and install. If the appliance has been left on its side for any length of time, leave it
standing upright for at least 10 minutes before turning on.
38
DO919RKG