Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION!
When connecting the solder sockets, do not solder
the sockets together with the filter. High
temperatures destroy internal parts which are
important to the function!
1.
Thoroughly flush pipework
2.
Install filter
• Note flow direction
• Install without tension or bending stresses
4.3 Drain for rinse water
The rinse water must be piped to the drain in such a
way that no back pressure can occur
1.
Discharge into drain connector
2.
Discharge into floor drain
Filter size
Reverse rinsing quantity* C (mm)
1/2" - 1 1/4"
25 litres
*at 4 bar inlet pressure and a rinse duration of 15 seconds
5
Maintenance
In order to comply with EN 806-5, water fixtures must
be inspected and serviced on an annual basis.
As all maintenance work must be carried out by an
installation company, it is recommended that a
servicing contract should be taken out.
In accordance with EN 806-5, the following measures must
be taken:
5.1 Inspection
•
Non-compliance can lead to the filter becoming
blocked This results in a drop in pressure and
decreased water flow
•
The filter meshes are made of stainless steel. A red
coating as a consequence of rust from the pipelines
has no influence on function or the way the filter works
7
Troubleshooting
Problem
Too little or no water pressure
8
Spare Parts
For Spare Parts visit resideo.com
9
Accessories
For Accessories visit resideo.com
MU1H-1115GE23 R1123
GB
1.
2.
3.
4.
5.
5.2 Maintenance
5.2.1 Replace filter mesh
1.
20
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
6
Observe the local requirements regarding correct waste
recycling/disposal!
Cause
Shut-off valves upstream or downstream
from filter not fully open
Filter mesh dirty
Not fitted in flow direction
3
Close shut-off valve on inlet and outlet
Release pressure on outlet side (e.g. through water
tap)
If rinse water goes into a container, a suitable
container must first be placed below it.
Use the wrench to disassemble the filter bowl.
Replace filter mesh and supporting body in filter insert
Reassemble in reverse order
If necessary, the outside surface of the filter
combination can be cleaned.
Use only cold, clear drinking water to clean the
surfaces! Any other cleansers cause damage to the
plastic components!
Close shut-off valve on inlet and outlet
Release pressure on outlet side (e.g. through water
tap)
Unscrew filter bowl
• Use double ring wrench ZR06F
Remove filter cartridge
Dismount filter insert
Replace filter mesh by a complete new one
Flush the new filter insert and the filter bowl with clear
drinking water
Mount the filter insert
Re-insert the filter insert
Put O-ring on filter bowl
Screw in filter bowl hand-tight (without tools)
Slowly open shut-off valve on inlet
Slowly open shut-off valve on outlet
Disposal
Remedy
Open the shut-off valves fully
Replace filter mesh by a complete new
one
Fit filter in flow direction
Publicidad
