CONGA ROCKSTAR MICRO + ANIMAL Manual De Instrucciones página 39

Fig. 4 key:
1. Head release button
2. Trigger
Indicator light. Fig. 5
- When the vacuum cleaner is charging, the indicator will light up and keep flashing.
- When the vacuum cleaner is fully charged, the indicator will stop flashing and light up
steady.
- When using the vacuum cleaner, the indicator will stay lit.
- When the vacuum cleaner's battery is low, the indicator will flash.
Charging the vacuum cleaner. Fig. 6
1. Make sure the vacuum cleaner is switched off.
2. Plug the adapter into a socket and the vacuum cleaner.
3. An indicator light will light up and keep flashing once the adapter is connected to the
vacuum cleaner.
It's normal for the adapter to become warm during charging.
4. CLEANING AND MAINTENANCE
- Always turn off and unplug the appliance before cleaning it.
- Use a soft, slightly dampened cloth to clean the surface of the appliance.
- Never immerse the appliance in water or other liquids, do not allow liquids to enter the
appliance.
- Do not use abrasive cleaners or scouring pads to clean the appliance.
- Do not leave the appliance in a place with direct sunlight.
- Do not leave the appliance in a wet place after cleaning it.
Cleaning the filters and tank. Fig. 7
- To avoid the appliance from overheating and losing suction power, it is suggested to clean
the filters frequently. To make the most of the suction power, it is suggested to clean the
filter after every use.
- The filters shelf life will depend on the accumulated use and the type of particles which
are frequently vacuumed. It is recommended to replace the filters approximately every 6
months.
1. Make sure the vacuum cleaner is switched off and is not connected to a mains socket.
2. Press the dust-tank release button and remove it.
3. Remove the filter system from inside the tank and separate the filters for cleaning.
4. Put the filters back in their original position inside the dust tank.
CONGA ROCKSTAR MICRO + ANIMAL
ENGLISH
39