Hoover CLEANSLATE XL Manual Del Usuario página 3

MAINTENANCE
WARNING:
To reduce the risk of
personal injury, unplug before cleaning or
servicing.
HOW TO CLEAN TOOLS
1
Remove the tool from the hose. Rinse
hand tool under faucet. Remove the
nozzle cover by unlatching the clear tab.
2
Remove Insert and rinse under faucet.
HOW TO CLEAN HOSE
1
To clean out the hose, empty the Solution Tank
and fill with warm water to the Water Fill Line
(max 140 degrees F (60 degrees C)). Ensure both
tanks are secured on the unit before using Hose
Cleaning Port.
2
Turn unit on and insert hose into hose cleaning
port. Hold down the trigger for 10-15 seconds
for water to flush through the hose and clean
any left-behind dirt and debris. *Repeat, as
necessary.
3
Empty the excess water from the dirty water
tank and rinse with warm water to clean.
CLEANING THE FILTER GRILL
1
Remove recovery tank from the machine by
lifting the tank up and away from the machine.
2
Remove any dirt and debris from the filter grill
located underneath the recovery tank.
FORMULA CHART RATIO
FOR HOOVER
GENERAL CLEANING
Large Area: Recommended for cleaning larger areas.
Small Area: Recommended for cleaning smaller areas.
Please reference solution tank for dilution ratios.
THERMAL PROTECTOR
A thermal protector has been designed into
your cleaner to protect it from overheating.
When the thermal protector activates the
cleaner will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the
electrical outlet.
2. Empty Recovery Tank.
3. Inspect for any obstructions.
Clear obstructions if present.
4. When cleaner is unplugged and motor
cools for 30 minutes, the thermal
protector will deactivate and cleaning may
continue.
If the thermal protector continues to activate
after following the above steps, your cleaner
needs servicing.
STORAGE:
Wrap cord around the cord
hooks for convenient storage. Attach the
plug end to the cord.
For fast cord release, simply turn the cord
wraps 180 degrees to the right or left.
LUBRICATION:
The motor is equipped
with bearings which contain sufficient
lubrication for their lifetime. The addition of
lubricant could cause damage.
Do not add lubricant to motor bearings.
® PORTABLE SOLUTION
TOUGH STAINS
No water needed.