unscrewing the screws under the rear edge
of the top shown as (C) in the image.
After removing the work top,
the screws must be screwed
again under the rear edge of the
top showns as (D) in the image.
OPERATION
To see the parts of the control panel, please
refer to picture 07 on page 6.
17. Power: Press this button to turn on
your dishwasher, the screen lights up.
18. Delay: Press this button to set the
delayed hours for washing. You can
delay the start of washing up to 24
hours. One press on this button delays
the start of washing by one hour.
19. Half-load: half load indicator light.
20.
Rinse Aid: If the indicator is lit,
it means the dishwasher is low on
dishwasher rinse aid and requires a
refill.
21. Salt: If the indicator is lit, it means the
dishwasher is low on dishwasher salt
and needs to be refilled.
22.
Water Faucet: If the ndicator is lit,
it means the water faucet closed.
23.
Timer 3h : 3h wash time.
24.
Timer 6h: 6h wash time.
25.
Timer 9h: 9h wash time.
26.
Timer 12h: 12 wash time.
27.
Intensive:
crockery, and normally soiled pots,
pans, dishes etc. With dried-on food.
28.
Universal: For normally soiled
loads, such as pots, plates, glasses and
lightly soiled pans.
29.
Eco: This is the standard program
suitable for normally soiled loads,
such as pots, plates, glasses and
lightly soiled pans.
30.
90 min: For normally soiled loads
that need quick wash.
31. Glass: For lightly soiled crockery and
glass.
32.
Rapid: A shorter wash for lightly
soiled loads that do not need drying.
For heaviest soiled
33.
Half-load: When you have about
or less than 6 place setting dishware
to wash, you can choose this function
to save energy and water. (It can only
be used with Intensive, Universal,
ECO, Glass and 90 min.) Press together
buttons 90 min and Rapid program.
FIRST USE (see image 08 on page 6)
Before using the device for the first time,
please:
• Adjusting the water softener
• Fill the salt tank
• Fill the rinse aid dispenser
• Fill with detergent
Please read the instructions
carefully.
detergents and other products
used may cause irreparable
damage to your dishes or
appliance.
Water Softener
• The
water
softener
manually, using the water hardness
dial.
• The water softener is designed to
remove minerals and salts from the
water, which would have a detrimental
or adverse effect on the operation of the
appliance.
• The more minerals there are, the harder
your water is.
• The
softener
according to the hardness of the water
in your area.
• Your local Water Authority can advise
you on the hardness of the water in
your area.
Adjusting salt consumption
The dishwasher is designed to allow for
adjustment in the amount of salt consumed
based on the hardness of the water used.
This is intended to optimise and customise
the level of salt consumption.
Please
follow
the
adjustment in salt consumption (see table
02 on page 12).
Incorrect
use
must
be
should
be
adjusted
steps
below
EN
of
set
for
47