Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Caution: The screws supplied are for
wooden beams and concrete ceilings.
(fig. 2).
• Step 03: Remove the unthreaded screw
from the extension rod and save it.
Also remove the upper screws in the
hemisphere of the extension rod and
reserve them.
• Step 04: Pass through the support rod,
the canopy and the lower cover. Then
run the cables through the inside of
the rod. Fit the rod into the motor body
and replace the previously removed
threadless screw and tighten the motor
body screws (fig. 3).
• Step 05: Slide the lower cover to the
engine body.
• Step 06: Secure the support rod to the
engine using the engine pin and nut.
• Step 07: Place the hemisphere of the
support rod, tighten it with the screw
and connect the electric cable coming
from the roof to the screw terminal
located at the top of the support rod,
tighten the screws.
• Step 08: Then hang the fan to the
ceiling and make the appropriate
cable connections. Make sure that
the receiver is inserted into the top of
the support plate (see Connecting the
remote control).
• Step 09: Slide the top cover up and align
the holes to the screws, turning the top
panel until it locks into place. Then
tighten the screws. (fig. 4)
• Step 10: To mount the blades, center the
blade slots with the motor attachment
heads and tighten the screws. (fig. 6)
• Step 11: To mount the light, assemble
and align the holes in the back of the
LED light with the three screws on the
motor connection plate. (fig. 7)
• Step 12: Then tighten the three screws
on the LED board and connect the cable
along with the motor cable. Please
make sure that the lighting kit is
securely fastened after tightening the
screws. (fig. 8)
• Step 13: Place the lampshade on the fan
and turn it clockwise until it is fixed
(fig. 9).
32
Note: You can also mount the blades in
the fan body before making the electrical
connections.
Once you have finished the installation
make sure the product works correctly. Pay
special attention to any strange oscillation
or malfunction in any of the fan parts.
In case the product shows any imbalance
or vibration, you can use the balancing kit
included to adjust it.
Remote control connection:
See picture 06 on page 8.
L : AC IN 220-240V
N : AC IN 220-240V
Blade balance kit:
Included in the purchased product you will
find a kit supplied to prevent the blades
from moving unbalanced.
The fan may wobble during functioning
due to an irregularity in the blades or
blade support. Also, improper installation
or an inclined angle can cause additional
problems.
It is recommended to follow the next
procedure to solve any of these problems :
• Make sure that all blades are screwed
firmly into their mounts and are tight to
the fan body.
• Looking at the fan from below, check
and make sure that no blade holder is
bent so all the blades are in the correct
position.
• Using a ruler you can check the blade
route. Simply place the ruler against the
roof vertically, and note the distance
from the edge of the blade to the roof.
Carefully spin the blades with your
hand to check all the blades. If the
blades are not aligned, the holder can
be slightly bent up or down to align it
with the rest of the blades.
If after following all these steps the problem
is not solved, a small adjustment must be
made using the balance kid provided.
Publicidad
