Protecting The Environment; Service Information - Stanley STEL503 Manual De Instrucciones

16 • ENGLISH
f When changing from hammer drilling to chiselling,
turn the chisel to the desired position. If resistance
is felt during mode change, slightly turn the chisel to
engage the spindle lock.
Selecting the direction of rotation
For drilling, and for chiselling, use forward (clockwise)
rotation. For removing a jammed drill bit, use reverse
(counterclock-wise) rotation.
f To select forward rotation, push the forward/reverse
slider (3) to the left.
f To select reverse rotation, push the forward/reverse
slider to the right.
Warning! Never change the direction of rotation while
the motor is running.
SETTING THE DRILLING DEPTH (Fig. D)
f Slacken the side handle (6) by turning the grip
counter- clockwise.
f Set the depth stop (7) to the desired position.
The maximum drilling depth is equal to the distance
between the tip of the drill bit and the front end
of the depth stop.
f Tighten the side handle by turning the grip clockwise.
Switching on and off
f To switch the tool on, press the variable speed switch
(1). The tool speed depends on how far you press
the switch.
f As a general rule, use low speeds for large diameter
drill bits and high speeds for smaller diameter drill bits.
f For continuous operation, press the lock-on button
(2) and release the variable speed switch. This option
is available only in forward (clockwise) rotation.
f To switch the tool off, release the variable speed
switch. To switch the tool off when in continuous
operation, press the variable speed switch once more
and release it.
ACCESSORIES
The performance of your tool depends on the accessory
used. Stanley accessories are engineered to high quality
standards and designed to enhance the performance of
your tool. By using these accessories you will get the very
best from your tool.
MAINTENANCE
Your STANLEY corded/cordless appliance/tool has been
designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on
corded/ cordless power tools:
f Switch off and unplug the appliance/tool.
f Or switch off and remove the battery from the
appliance/tool if the appliance/tool has a separate
battery pack.
f Or run the battery down completely if it is integral and
then switch off.
f Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
f Regularly clean the ventilation slots in your appliance/
tool/charger using a soft brush or dry cloth.
f Regularly clean the motor housing using a damp
cloth. Do not use any abrasive or solvent-based cleaner.
f Regularly open the chuck and tap it to remove any
dust from the interior (when fitted).

PROTECTING THE ENVIRONMENT

Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your STANLEY product
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.

SERVICE INFORMATION

STANLEY offers a full network of company-owned and
authorized service locations. All STANLEY Service Centers
are staffed with trained personnel to provide customers with
efficient and reliable power tool service. For more information
about our authorized service centers and if you need technical
advice, repair, or genuine factory replacement parts, contact
the STANLEY location nearest you.