Publicidad
Idiomas disponibles
Idiomas disponibles
Before using the high pressure washer, carefully read all of the instructions and follow them scrupulously. The
manufacturer cannot be held responsible for damage to persons and/or property caused by improper use of the
equipment.
This instruction manual is an integral part of the equipment and must therefore be stored carefully and passed
on with the unit in the event of a change of ownership.
THE MINIMUM FLOW RATE OF THE WATER SUPPLY MUST NOT BE LOWER THAN THAT INDICATED ON THE
•
DATA PLATE
THE FEEDING WATER PRESSURE MUST NOT EXCEED 3 BAR. IF HIGHER, YOU MUST BE PROVIDED WITH
•
SUITABLE PRESSURE REDUCTION VALVE.
APPLIANCE NOT SUITABLE FOR CONNECTION TO THE DRINKING WATER NETWORK: THE PRESSURE
•
WASHER CANNOT
BE CONNECTED DIRECTLY TO THE DRINKING WATER DISTRIBUTION NETWORK WITHOUT HAVING
•
INSTALLED AN ANTI- BACKFLOW DEVICE IN THE SUPPLY PIPE WITH EMPTYING CAPACITY COMPLIANT
WITH CURRENT REGULATIONS. IT IS ALSO NECESSARY TO USE A REINFORCED PIPE WITH A DIAMETER OF
AT LEAST Ø13MM - ½ INCH
WATER PASSING THROUGH ANTI-BACKFLOW DEVICES CANNOT BE CONSIDERED DRINKABLE
•
USE ONLY FILTERED OR CLEAN WATER, PLACING THE PRESSURE WASHER AS CLOSE AS POSSIBLE TO THE
•
WATER SUPPLY NETWORK. THE WATER SUPPLY TAP MUST ALSO GUARANTEE A SUPPLY EQUAL TO TWICE
THE MAXIMUM FLOW RATE OF THE PUMP.
EACH TIME THE HIGH PRESSURE WASHER IS USED, AFTER EACH OPERATING CYCLE AND WHENEVER IT IS
•
LEFT UNSUPERVISED, EVEN IF NOT RUNNING, MAKE CERTAIN THAT THE ELECTRICAL AND HYDRAULIC
POWER SUPPLIES ARE COMPLETELY DISCONNECTED. THEREFORE, IN SUCH CASES:
•
USE THE KEY SWITCH AND TURN OFF THE ENGINE
•
ACT ON THE CLOSING TAP OF THE WATER SUPPLY PIPE DISCONNECTING THE HYDRAULIC SUPPLY
•
ACTIVATE THE TRIGGER OF THE GUN TO DISCHARGE THE EXCESS PRESSURE.
L-LC232.00-BM
EN
IMPORTANT
WARNING
WARNING
WARNING
22 / 40
Publicidad
