SOMFY LED RECEIVER io W POWERED 100W Manual De Instrucciones página 19

2.2.2. Activating/deactivating automatic cut-off
͉
Prerequisite: Commissioning has been completed using an io control point.
This function allows an LED light to be switched off automatically after 3, 6 or 12 hours of operation.
This duration can be configured (see 2.2.3.).
By default, this function is deactivated.
The procedure to follow to activate or deactivate automatic switch-off of each LED light is identical:
• Press the my and Down buttons simultaneously on the control
point until the LED light comes on then goes out.
- If the LED light comes on then goes out once: the function is
activated.
- If the LED light comes on then goes out twice: the function is
deactivated.
2.2.3. Setting the operating duration
You can configure the operating duration of each LED light before
automatic switch-off.
The default setting is 6 hours.
To alter these settings, for each LED light:
1) Briefly press the my and Down buttons simultaneously on the io
control point.
2) Immediately afterwards, press and hold the my and Down buttons
simultaneously until the LED light comes on then goes out.
• Briefly press the Down button to set the duration to 3 hours.
• Or briefly press the my button to set the duration to 6 hours.
• Or briefly press the Up button to set the duration to 12 hours.
The LED light comes on then goes out.
3) Press the my button until the LED light comes on then goes out.
The new setting has been programmed.
2.3. INSTALLATION TIPS AND ADVICE
2.3.1. Questions about the receiver?
Observations
The LED light does not react at all
when a button is pressed on the
control point
The LED light does not come on.
Poor radio performance.
Copyright 2023 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
5175298A000_LED RECEIVER IO W POWERED 100200W.indb 19 5175298A000_LED RECEIVER IO W POWERED 100200W.indb 19
Possible causes
The control point is not
programmed in the receiver.
The control point batteries are
low.
The control point used is not
compatible with the receiver.
The mains power supply is faulty.
The wiring is incorrect.
The ambient temperature is high
(> 45°C).
The receiver is installed in a metal
box.
The antenna is damaged.
1) 1)
0.5 s
2) 2)
< 2 s
= 3 h 00 = 6 h 00 = 12 h 00
3) 3)
Solutions
Follow the commissioning
procedure (see 2.2.)
Replace the batteries, using
batteries with the same
specifications.
Ensure that the two products are
compatible.
Check the power supply.
Check the wiring (see 2.1.)
Wait for the temperature to cool
down.
Install the product away from any
partition, column or metal cavity
that could alter the radio range.
Contact the After-Sales service.
27/10/2023 11:41:52 27/10/2023 11:41:52
EN
19