Black and Decker NPP2018 Manual De Instrucciones página 13

Ifyoutrytocutoffthick branches
from thebottom, thebranch m ay
close inand pinch t hesaw chain
inthecut. I fyoutrytocutoffthick
branches from thetop, w ithout a ...........
shallow u ndercut, thebranch m ay_ i
splinter figure 24.
Donot f orce Pole Saw. The motor
wilt o verload andcan burn out.It
wilt d othejobbetter and safer a t
therate forwhich itwas intended.
3. Remove Pole Saw from cutwhile
itisrunning atfullspeed. Stop Pole Saw byreleasing trigger.
Make sure chain has stopped before s etting P ole Saw down.
Saw chain sharpness
The cutters will dull immediately if they touch the ground or a nail
while cutting.
Saw chain tension
This should be done regularly. Refer to page 8 "Adjusting Chain
Tension".
\
Pole Saw Maintenance Section
Regular maintenance ensures a long effective life for the tool.
After every 10 minutes of use be sure to remove the battery (be
aware the chain and bar can be hot!) check the bar and chain for
correct tension and lubricate per pole saw instruction manual.
Use only mild soap and damp cloth to clean the tool. Never let any
liquid get inside the tool; never immerse any part of the tool into a
liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by authorized
service centers or other qualified service organizations, always using
identical replacement parts.
Problem
• Tool will not
start.
Accessories
Replacement chain and bar are available from your nearest Black &
Decker service center.
Replacement chain # 623382-00, Replacement bar # 623381-00
The use of accessories not recommended in this manual may be
hazardous.
Troubleshooting Section
If your Pole Saw does not operate correctly check the following:
Possible Cause Possible Solution
• Battery not • Check battery installation.
• Unit will not
charge.
installed properly.
• Battery not •
charged.
• Lock-out button not •
actuated.
• Pole connections •
not properly
tightened.
• Battery not •
inserted into
charger.
• Bar / chain • Chain too tight. •
overheated.
• Lubrication "
needed.
• Chain is • Chain tension set •
loose, incorrectly.
Check battery charging
requirements.
Pull back on lock
button/actuate trigger.
Refer to instruction manual
for pole connections.
Insert battery into charger
until green LED appears.
Charge up to 9 hours if
battery totally drained.
Refer to section on
adjusting chain tension.
Refer to sections for chain
oiling application.
Refer to section for chain
tensioning.
13