Water2Buy W2B 110 Manual De Instrucciones página 26

Water Softener Troubleshooting:
WHAT KIND OF SALT IS BEST?
All Water2buy ™ water softeners are designed to use any water
softeners salt of good quality, including "rock," "pellet," "solar," or
"evaporated" types. All rock salt, regardless of source, contains
insoluble material, which collects at the bottom of the salt storage
tank and requires periodic clean out.
If purified salt products are used, the salt storage compartment will
require less frequent clean out, but you must check more frequently
to prevent a "bridging" problem.
HOW MUCH SALT SHOULD I PUT INTO THE BRINE
TANK?
Salt levels need to be maintained at approximately 100mm above
the bottom of the tank and 50mm from the top of the tank.
HOW CAN I START A MANUAL REGENERATION
CYCLE?
On Timer Models
On timer models you can start a manual regeneration by turning the
manual backwash knob clockwise to the first position.
Do not run a manual backwash immediately before, after or during
an automatic backwash. The process will take approximately 2
hours. Make sure the backwash knob returns to the service position
when the cycle is complete.
On Meter Models
Make sure the backwash knob is at the 'SERV' position.
Unlock the screen by holding the ❑ 'menu' button.
Hold the ■ 'set' button till text on display changes
Press the ■ 'set' button and value starts flashing and can be edited.
Use the ▼ down arrow to select 'METER IMMEDIATE'.