AGP QS600 Manual De Instrucciones página 4

INTRODUCTION
This drill stand is designed to mount diamond core drilling motors by using a suitable motor mounting plate.
A standard 4 bolt (+2) motor mounting plate is included with this stand. The drill stand guides the motor and
diamond core bit so that it is possible to drill perfectly straight cuts in a safe and controlled manner.
The stand is also able to slant so that holes may be cored at an angle as required.
This stand must be securely fastened to the workpiece using a concrete anchor and fixing kit.
WARNING: Do not attempt to use this drill stand if the mounting system does not fit perfectly to the
drilling motor. Loose mounting will cause a hazardous situation.
PACKAGE CONTENTS
• Drill Stand
• Crank Handle
• Motor Mount Plate
• Wheels
MOUNTING THE DRILL STAND TO THE WORK SURFACE
Once the desired position of the stand is determined, use a concrete
anchor to secure it.
Drill a suitable sized hole for the anchor with a hammer drill.
Drive in the anchor.
Thread the rod from the fixing kit into the anchor, add the anchoring
plate, the washer, and speed nut in the fixing kit.
Before fully tightening the nut, use the spirit levels to check if the stand
is level. If needed, loosen the locknuts, and adjust the four leveling
screws to achieve levelness. Then retighten the locknuts.
Now fully tighten the speed nut which affixes the base to the work
surface.
WARNING: When anchoring to a brick surface, a special masonry
anchor and brick fixing kit must be used. Using a concrete type
drop-in anchor in brick could lead to the brick cracking and the
anchor loosening!
MOUNTING THE MOTOR TO THE DRILL STAND
The drill stand's motor mounting plate must be bolted to the drill motor. The mounting tenon must fit securely
in the slot in the back of the drill motor, then evenly tighten the four (or 6) bolts. (If the last two holes do not
correspond to holes in the drill motor, the 4 bolts are fully sufficient to hold the motor.)
GB
4
Fixing Kit
Anchoring Plate
Fixing Kit