Publicidad
Idiomas disponibles
Idiomas disponibles
GB
This motor mounting plate now acts as a secure and accurate
Motor Mount (quick-release)
coupling between the motor and the drill stand.
To install the motor head unit to the drill stand, pull the cradle lock
shaft out until it stops. The pins of the motor mounting plate fit in
the hooks in the stand's cradle and the plate is rotated into the slot
in the cradle. Secure by pushing the cradle lock shaft all the way in,
then, using the crank handle as a wrench, turn the cradle lock shaft
clockwise to lock. Removal is the opposite of installation.
Cradle Lock (eccentric)
ADJUSTING THE DRILLING ANGLE
0 to 45 degrees
The drilling angle can be tilted from 0 to 45 degrees. To adjust the
angle, use the crank handle as a wrench and loosen the angle clamp
bolt. Refer to the scale on the column indicating the angle. Adjust to
the desired angle and tighten the clamp.
CAUTION: Do not overtighten the clamp. Only tighten the
necessary amount to make the clamp secure. Extreme
overtightening could distort the column.
CARRIAGE LOCK
Pull up on the carriage lock and turn 90° so that the carriage lock's
carriage lock's pin
pin drops down to its lower position to lock. To release, pull up on
the carriage lock and turn 90° so that the carriage lock's pin is held in
its higher position in the notch on the carriage.
CAUTION: Hold the crank lever or motor head whenever
releasing the carriage lock. It could slam down causing possible
injury or damage.
REDUCTION GEARING
There are two crank spindles:
The rearward spindle is for standard fast cranking and the forward
Standard Ratio
spindle is for reduced gear ratio cranking. The reduced gear ratio
allows the operator to drill with greatly reduced effort when using
large diameter core bits.
Reduced Ratio
To switch from standard to reduced gear ratio cranking, simply
remove the crank handle from the main spindle and connect to the
forward spindle.
5
Publicidad
