Silverline 633630 Manual De Instrucciones página 10

EN
Troubleshooting
Problem Possible Cause Solution
Pressure incorrect Set the correct air pressure according to the specification
Dirt within the mechanism Repeat the 'Daily maintenance procedure' several times to clear the dirt
Tool operating slowly
Air blockage Operate tool in short bursts to clear blockage
Check all fittings and hose for air leaks and correct issue by
Air leak
re-tightening, using PTFE tape or replacing
Dirt or rust in mechanism See 'Tool operating slowly' solutions
Tool seized Dirt or rust in mechanism Tap tool gently with a soft mallet
Dirt or rust in mechanism Free mechanism by rotating drive manually when disconnected from air line
Accessory fitted incorrectly Remove accessory, inspect for damage and refit
Strong vibrations when tool is
switched on
Accessory damaged (cracks, deformations or splinters) Replace cutting accessory
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
10