Publicidad
Idiomas disponibles
Idiomas disponibles
QUICK START
For the following procedure you will need a CD player and headphones.
1. Set the controllers to their initial position
Set the rotary controllers GAIN, HI, MID and LOW from channel 1 (17, 18, 19, 20) to the central snap-in position.
Put the channel fader (23) down and move the A/OFF/B switch (22) to position A (this channel is now assigned to
the crossfaders' A side).
2. Connect the headphones
Connect your headphones to one of the outputs on the mixer's front
panel (36). Set the MONITOR LEVEL (35) to minimum and move the
MONITOR SELECT control (34) to the PFL position.
3. Connect a CD player
Connect a CD player to LINE input on channel 1 (39), insert a CD and
play the CD.
4. Connect the mixer's power cable
Connect the power cable to power source input (54) on the mixer's back
side and turn the mixer on by pressing the MAINS INPUT switch (52).
5. Select the input source
Make sure that the input source selector on channel 1 (13) is in LINE
position and that the channel's VU-meter (16) lightens up. If this does
not happen make sure that CD player is correctly connected and that
there is an audio track being played back.
6. Adjust the input level
Turn the GAIN control (17) until the VU-meter shows 0dB. Each
channel's red overload LED OVL (14), lightens up if the input level for
this channel is to high and has to be diminished with the channel's GAIN
controller.
7. Send the signal to the main output
Set the fader on channel 1 (23) to maximum and place the crossfader
(24) on side A.
8. Listen to the signal with your headphones
Press the PFL button (21) on channel 1. Adjust the MONITOR LEVEL
controller (35) to obtain a comfortable monitoring volume. Now you
should hear music with your headphones. Turn the MONITOR SELECT
controller (34) to the right to crossfade the PFL signal and the MIX
signal. When this controller is completely turned to the right, only the
MIX signal will be monitored.
9. Try the operation of the tone controllers
Experiment with this powerful 3-way stereo equaliser (18, 19, 20). This
tone control has been designed for a creative sound edition: each way
can be individually isolated using the big and ergonomic rotary
controllers.
10. Check the adjustment of the crossfader
Each channel can be assigned to the crossfader using the A/OFF/B selector switch. The crossfader allows you to
melt the signals that are assigned to both of its sides. With this selector in position A or B, you assign the channel
to one of both sides of the crossfader. The OFF position disables the crossfader's function on this channel.
11. Adjust the crossfader curve
The XFADER SHAPE controller (33) allows a fine adjustment of the crossfader curve's slope. Setting this controller
all left, the signal is diminished when the crossfader reaches the central position, which allows mixing two songs
with a soft melting. The crossfader curve's slope increases if the controller is turned to the right. When is gets
completely turned to the right, the signal enters very fast with hardly a movement of the crossfader. This is very
useful for scratching.
4
Publicidad
