SAMCO Cremoso Instrucciones Para El Uso página 8

EN
OPERATING INSTRUCTIONS
A. Preparing frothy cold milk
• Open the plastic lid and make sure the Stir set is properly positioned at the bottom
of the jug.
• Pour fresh milk into the jug, make sure not to exceed the max. level.
• Plug the power cord into a wall socket.
• When this button
heater at the bottom will not be activated, and the Stir set will rotate at a high speed .
• When this button
the heater at the bottom will not be activated, and the Stir set will rotate at a low speed.
• The milk inside will be agitated, but will not be heated up. After a short time (about 1
min.), the Stir set will stop rotating, at which point the milk inside should be frothy
and ready to serve.
B. Preparing frothy warm milk
• Open the plastic lid and make sure the Stir set
of the jug.
• Pour fresh milk into the jug, make sure not to exceed the max. level.
• Plug the power cord into a wall socket.
• When this button
at the bottom will be activated, and the Stir set will rotate at a high speed.
• When this button
the heater at the bottom will be activated, and the Stir set will rotate at a low speed .
• The milk inside will be agitated and heated up.
• After a short time (about 1 min.) when the milk has reached the pre-set temperature
of 70°C, the Stir set will stop rotating and the heater will be disactivated. The milk
inside will be warm and frothy and ready to serve.
- - Use - -
is pressed, the button will light up blue and flash quickly, the
is held down for 3s, the button will light up blue and flash slowly,
is pressed, the button will light up red and flash quickly, the heater
is held down for 3s, the button will light up red and flash slowly,
- 8 -
is properly positioned at the bottom