Publicidad
Idiomas disponibles
Idiomas disponibles
REF.54522
2. If the device stops working, check that it is
correctly connected, and the condition of the
plug is correct, as well as the fuses or the cir-
cuit breaker.
3. Let the device cool down for 10 minutes and
try reconnecting. If the problem persists, con-
tact your supplier.
4. Using a suitable extension cord (too long or
too narrow) may affect its operation.
5. For other problems contact your supplier.
INDICATOR LIGHTS
The following table shows the different states
of the equipment according to the colour of
the light displayed:
Green
Yellow
Flashing
yellow
Flashing red
Red
WARNING SYMBOLS
The equipment must not be used by
persons with pacemakers or other
metal or electronic implants.
The equipment may only be used by
authorised personnel
Risk of explosion
Risk of fire
Risk due to strong magnetic field
intense magnetic field!
Risk due to intense heat source!
In standby position
Heating in progress
The device is overheated
Coil in bad condition or
excess power
Error
MAINTENANCE
Switch off the induction heater and allow the
appliance and all work coils to cool down for
at least 30 minutes before disassembly, clea-
ning and storage.
Handling the appliance or parts before they
have cooled down can cause burns. Storage
may also result in damage to parts of the
equipment or pose a fire hazard.
1. If you have finished working, switch off
the induction heater by releasing the on/off
switch. Make sure that the internal fan stops.
2. Interrupt the power supply.
3. Place the appliance and the coils once
they have cooled down in the foam rubber
notches of the storage case.
CLEANING
For cleaning, make sure that the appliance is
switched off and unplugged from the mains.
Use a clean, dry, soft paper or tissue cloth
to remove grease, oil and other dirt from the
induction heater, tools and electrical cords
before returning the appliance to the case.
For more stubborn grease, oil and dirt, use
non-volatile products commonly available in
the automotive industry for interior cleaning.
Allow all components to dry completely before
using the induction heater again.
WARRANTY
The warranty period is 1 year after purcha-
se of the item by the end customer. The
warranty does not cover induction wires.
The warranty only covers factory damage
due to use for the purpose for which the item
is designed, it does not take into account da-
mage due to misuse or insignificant defects,
therefore damage to the material due to ex-
cessively hard use or lack of maintenance of
the equipment does not fall within the scope
of the warranty. It also does not cover da-
mage caused after replacement of parts
or modification of the original equipment.
· 9 ·
Publicidad
