Polisher Operation - Hitachi Koki SP 18SB Manual De Instrucciones E Instrucciones De Seguridad

9. Installing the air cover
Install the air cover on the air vent on the
side where the side handle is attached to
divert the cooling air flow of the motor
during operation as much as possible. Hook
tab of the air cover to the air vent and push
in the tab when installing. Use a screwdriver
etc. to pull as shown in Fig. 2 when remov-
ing.

POLISHER OPERATION

1. Hold the polisher firmly by its housing and side handle (Fig. 1).
The polisher produces a counterforce which must be controlled by firmly holding onto
the polisher.
2. Switch operation
This enables the polisher always to be controlled with the hand gripping the machine for
maximum safety during polishing operations.
<Intermittent use>
Switch ON:
Switch OFF: Release the switch trigger.
<Continuous use>
Switch ON:
Switch OFF: Press and release the switch trigger.
3. Use light polishing pressure.
There is no need to press hard when polishing. Usually the polisher's own weight is
sufficient to allow the required light contact with the surface to be ground.
CAUTION: Do not press the polisher forcibly against the surface to be ground. Heavy
pressure can damage the surface being ground or damage the polisher's
motor.
4. Use of polishing compound or wax
Depending on the finishing degree of the surface, use the polishing compound or wax.
In order to attain the maximum polishing effect, first polish the surface with the fine sand
paper using the sander, then polish it with the polishing compound using the wool
bonnet, and then finish with wax. Apply a small quantity of the compound and wax to the
surface, and polish with the wool bonnet.
5. Beware of the cord during operation
CAUTION: Do not let the cord touch the wool bonnet during its operation, for the
rotating wool bonnet may catch the cord and roll it in.
Press the switch trigger.
Press the switch trigger. The switch trigger is locked by pushing on
the locking button.
English
Air cover
Fig. 2
11